Real jobs across Palmerston North, Feilding and the wider Manawatū. The problem the customer had, and what we actually did about it.
An old board with no RCD protection on the house circuits.
Full switchboard upgrade with RCDs and circuit breakers throughout, all new materials, then tested and certified.
Installation, servicing and hot water heat pumps.
Palmerston North
The problem: One heat pump was never going to heat the whole house.
What we did: Supplied and installed a Fujitsu hi-wall unit and a Fujitsu floor/ceiling console, with new circuits, cable runs, trunking and circuit breakers for both. Oven installed on the same visit. Tested and certified.
Aokautere
The problem: No heating in the main living area.
What we did: Supplied and installed a Gree 6.4kW indoor and outdoor unit with new trunking, new pipework and a new power feed. Tested and certified.
Bunnythorpe
The problem: Unit had run for years without a service and was not performing like it used to.
What we did: Indoor unit cleaned, filters and coils cleaned, refrigerant levels and amps checked, electrical connections checked, and the overall operation tested.
Upgrades from old fuses to RCD protection, tested and certified.
Manawatū
The problem: An old board with no RCD protection on the house circuits.
What we did: Full switchboard upgrade with RCDs and circuit breakers throughout, all new materials, then tested and certified.
Palmerston North
The problem: A full renovation needing the electrical brought up to current standards throughout.
What we did: Two bathroom heater/fan/light units with new external venting, bathroom power and lighting redone, lounge and dining lighting replaced with new cables fished through the ceiling, new bedroom sockets, wiring for a hot water heat pump, and a switchboard upgrade with MCB and RCD protection bringing the board up to current safety standards. Tested and certified.
Downlights, LED upgrades, sheds and outbuildings.
Ashhurst
The problem: A new shed with no power or light, and dated kitchen lighting in the house.
What we did: Wired the shed with floodlights inside and out and six power point outlets, then replaced the kitchen lighting with LED downlights and new bayonet fittings. Tested and certified.
Manawatū
The problem: A working shed with nowhere near enough light to work safely in.
What we did: Installed and connected LED batten lights with a new switch and the circuit run back to the board, then tested and certified.
Bulls
The problem: Dated lighting and not enough power points for how the rooms were actually used.
What we did: Supplied and installed ten downlights across the kitchen and living room and eight more across two bedrooms, then replaced the power points with new doubles and swapped out the old switches. Tested and certified.
Palmerston North
The problem: No light on an exterior approach.
What we did: Supplied and installed a twin PIR sensor LED floodlight, tested and certified with an electrical safety certificate.
Power points, circuits, ovens, fans, sensors and repairs.
Feilding
The problem: Two bathrooms being renovated and the electrical needed doing properly as part of it.
What we did: Full bathroom electrical package quoted up front and invoiced in two stages, so the homeowner knew the total before we started.
Palmerston North
The problem: New appliances going in and the existing circuits were not up to them.
What we did: New dedicated circuits for the oven and hob with isolation switches and RCBO protection, plus the circuit for a hot water heat pump. Tested and certified.
Kairanga
The problem: A bench power point in the wrong place and a laundry with no RCD protection.
What we did: Moved the bench point into the wall, added a new point below the bench and one in the laundry, and brought the laundry circuit up to RCD protection.
Palmerston North
The problem: Tired light fittings and power points through the house.
What we did: Replaced the light fittings and power points, including new hallway lights. Customer supplied some of their own fittings, which we were happy to install.
Palmerston North
The problem: Pantry sensor had stopped working.
What we did: Diagnosed and replaced the faulty sensor, then tested, certified and issued an electrical safety certificate.
"Great heat pump install, was professional and tidy."
"Kees installed new lights in my kitchen and installed a heat pump. I was very impressed."
"Communication was great, they installed multiple power points and switches. Everything went really smooth, would highly recommend to anyone looking for an electrician in Feilding."
"5 star +, very professional with top-notch workmanship. Would highly recommend this young man to anyone, and also went above and beyond for us."
Leave your details and Kees will give you a yell. Honest advice, a fixed quote, no pressure.
Get a free quote from a registered local electrician - leave your details and Kees will give you a yell. Honest advice, no pressure, no shortcuts.
